...is there a joke Im missing there, or am I just being weird?
...is there a joke Im missing there, or am I just being weird?
Envy seems lower than 30cm...
No 30cm is about right I think.
ok kody you are making the effort so i shall to so i went and measured it to the mm ok here we are......
27cm high at the highest point including pretruding wheels. 24cm without wheels.
the top flat bit is 27cm long and 80cm across
from the flat wide bit which is 80cm it goes to the front scoop which is 34cm wide
from the flat top bit toward the rear it goes down from 80cm to 54.5cm.
the flat rear end is 54.5 by 16 high i think you should be able to get the angles from that.
the flipper is 55cm long by 34 wide. then the front scoop is 11.5 from the edge of the flipper to the front tip of the robot.
i hope you understand this but if you dont please ask and i will go measure cos the robot is just in the other room.
thanks kodster
Ta, Shane.
Sorry about the delays, too much going on right now, almost had it ready, Shane. It will be ready soon, I hope. :sad:
take your time kody no worries
Fantastic pictures, Kody
Thank ee, Mr. McConnell.
Bookmarks